Danfoss VLT AutomationDrive FC 301 Programming Manual page 436

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[62] Counter A (up)
[63] Counter A (down)
[64] Counter B (up)
[65] Counter B (down)
[70] Start timer 3
[71] Start timer 4
[72] Start timer 5
[73] Start timer 6
[74] Start timer 7
[120] Start homing
[121] Stop homing
[122] Enable reference
[123] Disable reference
[124] Relative position
[125] Absolute position
436 | Danfoss A/S © 2022.12
Description
Starts timer 3, see parameter 13-20 SL Controller Timer for further description.
Starts timer 4, see parameter 13-20 SL Controller Timer for further description.
Starts timer 5, see parameter 13-20 SL Controller Timer for further description.
Starts timer 6, see parameter 13-20 SL Controller Timer for further description.
Starts timer 7, see parameter 13-20 SL Controller Timer for further description.
This option is available only with software version 48.20 and newer.
Activates the homing mode and starts the homing function selected in parameter 17-80 Hom-
ing Function. Must remain active until the homing is completed otherwise the homing is abor-
ted.
This option is available only with software version 48.20 and newer.
Deactivates the homing mode, an active homing function is aborted if the homing is not com-
pleted.
This option is available only with software version 48.20 and newer.
Sets the enable reference mode.
This option is available only with software version 48.20 and newer.
Disables the enable reference mode.
This option is available only with software version 48.20 and newer.
Selects the relative position mode instead of the absolute position mode.
This option is available only with software version 48.20 and newer.
N O T I C E
N O T I C E
N O T I C E
N O T I C E
N O T I C E
N O T I C E
AU275636650261en-000101 / 130R0334
Parameter Descriptions