Danfoss VLT AutomationDrive FC 301 Programming Manual page 290

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[108] PPO 8
[200] Custom telegram 1
[202] Custom telegram 3
Parameter 8-41 Parameters for Signals
Table 519: Parameter 8-41 Parameters for Signals
8-41 Parameters for Signals
Default value: [0] None
Conversion index: –
Option Name
[0]* None
[15] Readout: actual setup
[302] Minimum reference
[303] Maximum reference
[312] Catch up/slow down value
[321] Touch target
[322] Master scale numerator
[323] Master scale denominator
[326] Master offset
[328] Master offset speed ref
[341] Ramp 1 ramp up time
[342] Ramp 1 ramp down time
[351] Ramp 2 ramp up time
[352] Ramp 2 ramp down time
[380] Jog/homing ramp time
[381] Quick stop ramp time
[411] Motor speed low limit [RPM]
[412] Motor speed low limit [Hz]
[413] Motor speed high limit [RPM]
[414] Motor speed high limit [Hz]
[416] Torque limit motor mode
[417] Torque limit generator mode
[482] Power limit motor mode
290 | Danfoss A/S © 2022.12
Description
Enables use of freely configurable telegrams or standard telegrams for the FC port.
Parameter type: Option, Array [1000]
Data type: Uint16
Parameter Descriptions
Setup: All setups
Change during operation: False
Description
AU275636650261en-000101 / 130R0334