Danfoss VLT AutomationDrive FC 301 Programming Manual page 36

VLT AutomationDrive FC 301/302
Programming Guide
Option
[48]
[49]
[50]
[51]
Parameter 0-02 Motor Speed Unit
Table 8: Parameter 0-02 Motor Speed Unit
0-02 Motor Speed Unit
Default value: [0] RPM
Conversion index: –
This parameter cannot be adjusted while the motor is running.
Changing the motor speed unit resets certain parameters to their initial value. Select the motor speed unit before modifying oth-
er parameters.
The information shown in the display depends on the settings in parameter 0-02 Motor Speed Unit and parameter 0-03 Regional Set-
tings. The default settings of parameter 0-02 Motor Speed Unit and parameter 0-03 Regional Settings depend on the region to which
the drive is supplied.
Option Name Description
[0] RPM Select to show motor speed variables and parameters using motor speed (RPM).
[1] Hz Select to show motor speed variables and parameters using output frequency (Hz).
Parameter 0-03 Regional Settings
Table 9: Parameter 0-03 Regional Settings
0-03 Regional Settings
Default value: [0] International
Conversion index: –
This parameter cannot be adjusted while the motor is running.
Option Name
[0] International
[1] North America
36 | Danfoss A/S © 2022.12
Name
Polski
Russian
Thai
Bahasa Indonesia
Parameter type: Option
Data type: Uint8
N O T I C E
N O T I C E
Parameter type: Option
Data type: Uint8
N O T I C E
Description
Activate parameter 1-20 Motor Power [kW] for setting the motor power in kW and set the default value
of parameter 1-23 Motor Frequency to 50 Hz.
Activate parameter 1-20 Motor Power [kW] for setting the motor power in hp and set the default value
of parameter 1-23 Motor Frequency to 60 Hz.
Parameter Descriptions
Description
Setup: 2 setups
Change during operation: False
Setup: 2 setups
Change during operation: False
AU275636650261en-000101 / 130R0334