Danfoss VLT AutomationDrive FC 301 Programming Manual page 386

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[166] Relay 7
[167] Relay 8
[168] Relay 9
[180] Local reference ac-
tive
[181] Remote reference
active
[182] Start command
[183] Drive stopped
[185] Drive in hand mode
[186] Drive in auto mode
[187] Start command giv-
en
[190] Digital input X30/2
[191] Digital input X30/3
[192] Digital input X30/4
[193] Digital input X46/1
[194] Digital input X46/3
[195] Digital input X46/5
[196] Digital input X46/7
[197] Digital input X46/9
[198] Digital input X46/11
[199] Digital input X46/13
[212] Emergency mode
[222] Homing OK
[223] On target
386 | Danfoss A/S © 2022.12
Description
Active when parameter 3-13 Reference Site is [2] Local or when parameter 3-13 Reference Site is
[0] Linked to hand/auto, at the same time as the LCP is in hand-on mode.
Active when parameter 3-13 Reference Site is [1] Remote or [0] Linked to hand/auto, while the LCP
is in auto-on mode.
Active when there is an active start command and no stop command.
A stop command (jog, stop, qstop, coast) is issued – and not from the SLC itself.
Active when the drive is in hand-on mode.
Active when the drive is in auto-on mode.
This option is only available with software version 48.2X and newer.
Homing is completed with the selected homing function (parameter 17-80 Homing Function).
This option is only available with software version 48.2X and newer.
Positioning is completed and the on-target signal is sent when the actual position is within
parameter 3-05 On Reference Window for the duration of parameter 3-09 On Target Time and the
actual speed does not exceed parameter 3-05 On Reference Window.
N O T I C E
N O T I C E
AU275636650261en-000101 / 130R0334
Parameter Descriptions