Danfoss VLT AutomationDrive FC 301 Programming Manual page 320

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[4595] Sensor 3 [unit]
[4596] Sensor 3 [%]
[4597] Sensor 3 [unit]
[4598] Sensor 4 [%]
[4599] Sensor 4 [unit]
Parameter 9-27 Parameter Edit
Table 550: Parameter 9-27 Parameter Edit
9-27 Parameter Edit
Default value: [1] Enabled
Conversion index: –
Parameters can be edited via:
• PROFIBUS
• The standard RS485 interface
• The LCP
Option
[0]
[1]*
Parameter 9-28 Process Control
Table 551: Parameter 9-28 Process Control
9-28 Process Control
Default value: [1] Enable cyclic master
Conversion index: –
Process control (setting of control word, speed reference, and process data) is possible via either PROFIBUS or standard fieldbus, but
not both simultaneously. Local control is always possible via the LCP. Control via process control is possible via either terminals or
fieldbus depending on the settings in parameter 8-50 Coasting Select to parameter 8-56 Preset Reference Select.
Option
[0]
[1]*
Parameter 9-44 Fault Message Counter
Table 552: Parameter 9-44 Fault Message Counter
9-44 Fault Message Counter
Default value: 0
Conversion index: 0
320 | Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint16
Name
Disabled
Enabled
Parameter type: Option
Data type: Uint8
Name
Disable
Enable cyclic master
Parameter type: Range, 0 - 65535
Data type: Uint16
Parameter Descriptions
Description
Setup: 2 setups
Change during operation: False
Description
Setup: 2 setups
Change during operation: False
Description
Setup: All setups
Change during operation:
AU275636650261en-000101 / 130R0334