Danfoss VLT AutomationDrive FC 301 Programming Manual page 133

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[13] 24V Encoder 27/29
[14] MCB 102 Absolute
[15] MCO Encoder 1 X56
[16] MCO Encoder 2 X55
[20]* Digital Potmeter
[21] Analog Input X30/11
[22] Analog Input X30/12
[29] Analog Input X48/2
[37] Analog Input X49/1
[38] Analog Input X49/3
[39] Analog Input X49/5
Parameter 3-17 Reference Resource 3
Table 201: Parameter 3-17 Reference Resource 3
3-17 Reference Resource 3
Default value: [11] Local bus reference
Conversion index: –
Select the reference input to be used for the 3
ence 2, and parameter 3-17 Resource Reference 3 define up to 3 different reference signals. The sum of these reference signals defines
the actual reference.
Option Name
[0] No function
[1] Analog Input 53
[2] Analog Input 54
[3] 24V Encoder 32/33
[4] MCB 102
[5] MCB 103
[6] Virtual Master
[7] Frequency Input 29
[8] Frequency Input 33
Danfoss A/S © 2022.12
Description
Single signal generated from 24 V High Threshold Logic (HTL) encoder connected to terminals
27 and 29. Configure the 24 V encoder interface in parameter group 5.7* 24 V Encoder Input. Pro-
gram terminals 27/29 to [0] No operation.
The option is only available for VLT® Encoder Option MCB 102 with version 4.00 and newer and
when parameter 17-00 Encoders Connected is set to option [1] Two Encoders.
VLT® General Purpose I/O MCB 101
VLT® General Purpose I/O MCB 101
Parameter type: Option
Data type: Uint8
rd
reference signal. Parameter 3-15 Resource Reference 1, parameter 3-16 Resource Refer-
Description
This option is only available in FC 302.
Parameter Descriptions
Setup: All setups
Change during operation: True
N O T I C E
AU275636650261en-000101 / 130R0334 | 133