Danfoss VLT AutomationDrive FC 301 Programming Manual page 124

VLT AutomationDrive FC 301/302
Programming Guide
Option Name Description
[0] Min - Max Select the range of the reference signal and the feedback signal. Signal values can be positive only, or
positive and negative. The minimum limit may have a negative value, unless [1] Speed closed loop control
or [3] Process is selected in parameter 1-00 Configuration Mode.
[1] -Max - +Max
For both positive and negative values (both directions, relative to parameter 4-10 Motor Speed Direction).
Parameter 3-01 Reference/Feedback Unit
Table 184: Parameter 3-01 Reference/Feedback Unit
3-01 Reference/Feedback Unit
Default value: Size related
Conversion index: –
Select the unit to be used in process PID control references and feedbacks. Parameter 1-00 Configuration Mode must be either [3]
Process or [8] Extended PID Control.
Option
[0]
[1]
[2]
[3]
[4]
[5]
[10]
[12]
[20]
[21]
[22]
[23]
[24]
[25]
[30]
[31]
[32]
[33]
[34]
[40]
[41]
[45]
124 | Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
Name
None
%
RPM
Hz
Nm
PPM
l/min
Pulse/s
l/s
l/min
l/h
3
m /s
3
m /min
3
m /h
kg/s
kg/min
kg/h
t/min
t/h
m/s
m/min
m
Parameter Descriptions
Setup: All setups
Change during operation: True
Description
AU275636650261en-000101 / 130R0334