Main Menu Mode; Parameter Selection; Changing Data; Changing A Text Value - Danfoss VLT AutomationDrive FC 301 Programming Manual

VLT AutomationDrive FC 301/302
Programming Guide
The smart setup runs automatically on the first power-up of the drive or after a reset to factory settings. If no action is taken, the
SAS screen automatically disappears after 10 minutes.

4.1.7 Main Menu Mode

Press [Main Menu] to enter the main menu mode. The readout in the following illustration appears on the display. The middle and
bottom sections in the display show a list of parameter groups, which can be selected by toggling the [▵] and [▿] keys.
1107 RPM
Main Menu
0-** Operation/Display
1-** Load/Motor
2-** Brakes
3-** References/Ramps
Illustration 14: Main Menu Mode
Each parameter has a name and number which remain the same regardless of the programming mode. In the main menu mode,
the parameters are divided into groups. The first digit of the parameter number (from the left) indicates the parameter group num-
ber.
All parameters can be changed in the Main Menu. However, depending on the choice of configuration (parameter 1-00 Configura-
tion Mode), some parameters can be hidden. For example, open loop hides all the PID parameters, and other enabled options make
more parameter groups visible.

4.1.8 Parameter Selection

In the main menu mode, the parameters are divided into groups. Select a parameter group with the navigation keys.
After selecting a parameter group, select a parameter with the navigation keys.
The middle section on the display shows the parameter number and name, and the selected parameter value.
740R P M 10.64A
Basic S ettings
0 -01 Language
[0] English
Illustration 15: Parameter Selection

4.1.9 Changing Data

The procedure for changing data in the quick menu mode and the main menu mode is the same. Press [OK] to change the selected
parameter.
The procedure for changing data depends on whether the selected parameter represents a numeric data value or a text value.

4.1.10 Changing a Text Value

If the selected parameter is a text value, change the text value with the [▵] [▿] keys.
Place the cursor on the value to save and press [OK].
28 | Danfoss A/S © 2022.12
N O T I C E
3.84 A
1(1)
1 [1]
0-0*
How to Program
AU275636650261en-000101 / 130R0334