Danfoss VLT AutomationDrive FC 301 Programming Manual page 495

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 15-87 kWh Counter Hires
Table 815: Parameter 15-87 kWh Counter Hires
15-87 kWh Counter Hires
Default value: 0 kWh
Conversion index: 75
Register the power consumption of the motor as an average value over 1 hour. Reset the counter in parameter 15-06 Reset kWh
Counter. The decimal places are reset at power-up.
Parameter 15-89 Configuration Change Counter
Table 816: Parameter 15-89 Configuration Change Counter
15-89 Configuration Change Counter
Default value: 0
Conversion index: 0
This parameter cannot be adjusted while the motor is running.
5.15.13 15-9* Parameter Info
Parameter 15-92 Defined Parameters
Table 817: Parameter 15-92 Defined Parameters
15-92 Defined Parameters
Default value: 0
Conversion index: 0
View a list of all defined parameters in the drive. The list ends with 0.
Parameter 15-93 Modified Parameters
Table 818: Parameter 15-93 Modified Parameters
15-93 Modified Parameters
Default value: 0
Conversion index: 0
View a list of the parameters that have been changed from their default setting. The list ends with 0. Changes may not be visible
until up to 30 s after implementation.
Parameter 15-94 Extended Version
Table 819: Parameter 15-94 Extended Version
15-94 Extended Version
Default value: Size related
Conversion index: 0
INPUT MISSING
Danfoss A/S © 2022.12
Parameter type: Range, 0 - 2147483647 kWh
Data type: Uint32
Parameter type: Range, 0 - 65535
Data type: Uint16
N O T I C E
Parameter type: Range, 0 - 9999, Array [1000]
Data type: Uint16
Parameter type: Range, 0 - 9999, Array [1000]
Data type: Uint16
Parameter type: Range, 0 - 65, Array [10]
Data type: VisibleString
Parameter Descriptions
Setup: All setups
Change during operation: False
Setup: All setups
Change during operation: False
Setup: All setups
Change during operation: False
Setup: All setups
Change during operation: False
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334 | 495