Danfoss VLT AutomationDrive FC 301 Programming Manual page 351

VLT AutomationDrive FC 301/302
Programming Guide
Option
[0]
[1]
[2]
Parameter 12-14 Link Duplex
Table 617: Parameter 12-14 Link Duplex
12-14 Link Duplex
Default value: Size related
Conversion index: –
In POWERLINK, this parameter is locked to half duplex.
Forces the duplex for each port to full or half duplex. If parameter 12-12 Auto Negotiation is set to [1] On, this parameter is read-only.
Option
[0]
[1]
Parameter 12-18 Supervisor MAC
Table 618: Parameter 12-18 Supervisor MAC
12-18 Supervisor MAC
Default value: 0
Conversion index: 0
MAC addresses of currently active supervisors.
Parameter 12-19 Supervisor IP Addr.
Table 619: Parameter 12-19 Supervisor IP Addr.
12-19 Supervisor IP Addr.
Default value: 0
Conversion index: 0
IP addresses of currently active supervisors.
5.12.3 12-2* Process Data
Parameter 12-20 Control Instance
Table 620: Parameter 12-20 Control Instance
12-20 Control Instance
Default value: Size related
Conversion index: 0
This parameter is read-only. It shows the connection to the master.
Danfoss A/S © 2022.12
Name
None
10 Mbps
100 Mbps
Parameter type: Option
Data type: Uint8
N O T I C E
Name
Half duplex
Full duplex
Parameter type: Range, 0 - 2147483647
Data type: OctetString
Parameter type: Range, 0 - 2147483647
Data type: OctetString
Parameter type: Range, 0 - 255
Data type: Uint8
Parameter Descriptions
Description
Setup: All setups
Change during operation: True
Description
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
Setup: 1 setup
Change during operation: True
AU275636650261en-000101 / 130R0334 | 351