Danfoss VLT AutomationDrive FC 301 Programming Manual page 45

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[1675] Analog In X30/11
[1676] Analog In X30/12
[1677] Analog Out X30/8 [mA]
[1678] Analog Out X45/1 [mA]
[1679] Analog Out X45/3 [mA]
[1680] Fieldbus CTW 1
[1681] Fieldbus Sync. REF
[1682] Fieldbus REF 1
[1683] Fielbus Pos. REF
[1684] Comm. Option STW
[1685] FC Port CTW 1
[1686] FC Port REF 1
[1687] Bus Readout Alarm/Warning
[1688] Fieldbus Torque FF
[1689] Configurable Alarm/Warning
Word
[1690] Alarm Word
[1691] Alarm Word 2
[1692] Warning Word
[1693] Warning Word 2
[1694] Ext. Status Word
[1695] Ext. Status Word 2
[1696] Maintenance Word
[1697] Alarm Word 3
[1698] Warning Word 3
[1804] Mech Brake Count
[1820] Commanded Position
[1821] Master Position
[1823] Virtual Master Pos.
[1827] Safe Opt. Est. Speed
[1828] Safe Opt. Meas. Speed
[1829] Safe Opt. Speed Error
Danfoss A/S © 2022.12
Description
Actual value at input X30/11 either as reference or protection value.
Actual value at input X30/12 either as reference or protection value.
Actual value at output X30/8 in mA. Use parameter 6-60 Terminal X30/8 Output to se-
lect the value to be shown.
Control word (CTW) received from the bus master.
Mains reference value sent with control word from the bus master.
Extended fieldbus communication option status word.
Control word (CTW) received from the bus master.
Status word (STW) sent to the bus master.
One or more alarms in a hex code.
One or more alarms in a hex code.
One or more warnings in a hex code.
One or more warnings in a hex code.
One or more status conditions in a hex code.
One or more status conditions in a hex code.
The bits reflect the status for the programmed preventice maintenance events in
parameter group 23-1* Maintenance.
Parameter Descriptions
AU275636650261en-000101 / 130R0334 | 45