Danfoss VLT AutomationDrive FC 301 Programming Manual page 657
Hide thumbs
Also See for VLT AutomationDrive FC 301:
- Programming manual (372 pages) ,
- Design manual (214 pages) ,
- Operating instructions manual (112 pages)
Table of Contents
Advertisement
VLT AutomationDrive FC 301/302
Programming Guide
Parameter 36-61 Terminal X49/11 Digital Output
Table 1343: Parameter 36-61 Terminal X49/11 Digital Output
36-61 Terminal X49/11 Digital Output
Default value: [0] No operation
Conversion index: –
Option
Name
[0]*
No operation
[1]
Control ready
[2]
Drive ready
[3]
Drive rdy/rem ctrl
[4]
Enable/no warning
[5]
Running
[6]
Running/no warning
[7]
Run in range/no warn
[8]
Run on ref/no warn
[9]
Alarm
[10]
Alarm or warning
[11]
At torque limit
[12]
Out of current range
[13]
Below current, low
[14]
Above current, high
[15]
Out of speed range
[16]
Below speed, low
[17]
Above speed, high
[18]
Out of feedb. range
[19]
Below feedback, low
[20]
Above feedback, high
[21]
Thermal warning
[22]
Ready,no thermal W
[23]
Remote,ready, no TW
[24]
Ready, Voltage OK
[25]
Reverse
[26]
Bus OK
[27]
Torque limit & stop
Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
Parameter Descriptions
Setup: All setups
Change during operation: True
Description
AU275636650261en-000101 / 130R0334 | 657
Advertisement
Table of Contents
