Danfoss VLT AutomationDrive FC 301 Programming Manual page 327

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 9-94 Changed Parameters (5)
Table 577: Parameter 9-94 Changed Parameters (5)
9-94 Changed Parameters (5)
Default value: 0
Conversion index: 0
This parameters shows a list of all the drive parameters deviating from default setting.
Parameter 9-99 PROFIBUS Revision Counter
Table 578: Parameter 9-99 PROFIBUS Revision Counter
9-99 PROFIBUS Revision Counter
Default value: 0
Conversion index: 0
Readout of revision count.
5.11 Parameter Group 10-** CAN Fieldbus
5.11.1 10-0* Common Settings
Parameter 10-00 CAN Protocol
Table 579: Parameter 10-00 CAN Protocol
10-00 CAN Protocol
Default value: Size related
Conversion index: –
The options available depend on the installed option card.
Option
[0]
[1]
Parameter 10-01 Baud Rate Select
Table 580: Parameter 10-01 Baud Rate Select
10-01 Baud Rate Select
Default value: Size related
Conversion index: –
Select the fieldbus transmission speed. The selection must correspond to the transmission speed of the master and of the other
fieldbus nodes.
Option
[16]
[17]
[18]
[19]
Danfoss A/S © 2022.12
Parameter type: Range, 0 - 9999
Data type: Uint16
Parameter type: Range, 0 - 65535
Data type: Uint16
Parameter type: Option
Data type: Uint8
Name
CANopen
DeviceNet
Parameter type: Option
Data type: Uint8
Name
10 Kbps
20 Kbps
50 Kbps
100 Kbps
Parameter Descriptions
Setup: All setups
Change during operation: False
Setup: All setups
Change during operation:
Setup: 2 setups
Change during operation: False
Description
Setup: 2 setups
Change during operation: True
Description
AU275636650261en-000101 / 130R0334 | 327