Danfoss VLT AutomationDrive FC 301 Programming Manual page 131

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 3-15 Reference Resource 1
Table 199: Parameter 3-15 Reference Resource 1
3-15 Reference Resource 1
Default value: [1] Analog input 53
Conversion index: –
Select the reference input to be used for the 1
ence 2, and parameter 3-17 Resource Reference 3 define up to 3 different reference signals. The sum of these reference signals defines
the actual reference. Select the speed reference source in parameter 3-15 Reference Resource 1 when parameter 1-00 Configuration
Mode is set to [9] Positioning in positioning mode.
The options [3],[4],[5], [6], [12], [13], and [14] are only available with software version 48.XX.
Option Name
[0] No function
[1]* Analog Input 53
[2] Analog Input 54
[3] 24V Encoder 32/33
[4] MCB 102
[5] MCB 103
[6] Virtual Master
[7] Frequency Input 29
[8] Frequency Input 33
[11] Local Bus Reference
[12] Preset Reference
[13] 24V Encoder 27/29
[14] MCB 102 Absolute
[15] MCO Encoder 1 X56
[16] MCO Encoder 2 X55
[20] Digital Potmeter
[21] Analog Input X30/11
[22] Analog Input X30/12
[29] Analog Input X48/2
Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
st
reference signal. Parameter 3-15 Resource Reference 1, parameter 3-16 Resource Refer-
N O T I C E
Description
This option is only available in FC 302.
Reference from terminals 68 and 69.
Select this option to set the speed reference in parameter 3-10 Preset Reference together with
the preset target in parameter 3-20 Preset Target to calculate speed profile for positioning.
VLT® General Purpose I/O MCB 101
VLT® General Purpose I/O MCB 101
Setup: All setups
Change during operation: True
N O T I C E
AU275636650261en-000101 / 130R0334 | 131
Parameter Descriptions