Danfoss VLT AutomationDrive FC 301 Programming Manual page 283

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[233] Power limit both
[234] Light load+evacu-
ation
[235] Setup bit 0
[236] Setup bit 1
Parameter 8-17 Configurable Alarm and Warning Word
Table 506: Parameter 8-17 Configurable Alarm and Warningword
8-17 Configurable Alarm and Warningword
Default value: [0] Off
Conversion index: –
The configurable alarm and warning word has 16 bits (0–15). Each of those bits can be configured to any of the following options.
Option Name
[0]* Off
[1] 10 Volts low warning
[2] Live zero warning
[3] No motor warning
[4] Mains phase loss warning
[5] DC link voltage high warning
[6] DC link voltage low warning
[7] DC overvoltage warning
[8] DC undervoltage warning
[9] Inverter overloaded warning
[10] Motor ETR overtemp warning
[11] Motor thermistor overtemp warning
[12] Torque limit warning
[13] Over current warning
Danfoss A/S © 2022.12
Description
This option is only available in FC 302.
See parameter group 4-8* Power Limit. Use this option in both the motor and the generating
modes.
This option is only available in FC 302.
Use this option to ensure that the drive runs in the direction which requires least energy (UPS ca-
pacity), during an emergency and to operate the drive at reduced DC-voltage for evacuating peo-
ple in case of power failure.
Parameter type: Option, Array [16]
Data type: Uint16
N O T I C E
N O T I C E
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334 | 283
Parameter Descriptions
Description