Danfoss VLT AutomationDrive FC 301 Programming Manual page 159

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 4-26 Power Limit Gener. Factor Source
Table 276: Parameter 4-26 Power Limit Gener. Factor Source
4-26 Power Limit Gener. Factor Source
Default value: [0] No function
Conversion index: –
Select the input that scales the value in parameter 4-83 Power Limit Generator Mode from 0% to 100%.
Option
[0]*
[2]
[4]
[6]
[8]
[10]
[12]
[14]
[16]
5.5.3 4-3* Motor Feedback Monitoring
This parameter group includes monitoring and handling of motor feedback devices, such as encoders and resolvers.
Parameter 4-30 Motor Feedback Monitoring Loss Function
Table 277: Parameter 4-30 Motor Feedback Loss Function
4-30 Motor Feedback Loss Function
Default value: Size related
Conversion index: –
This function is used to monitor consistency in the feedback signal, that is if the feedback signal is available. Select which action the
drive should take if a feedback fault is detected. The selected action is to take place when the feedback signal differs from the out-
put speed by the value set in parameter 4-31 Motor Feedback Speed Error for longer than the value set in parameter 4-32 Motor Feed-
back Loss Timeout.
Option
[0]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
Name
No function
Analog in 53
Analog in 53 inv
Analog in 54
Analog in 54 inv
Analog in X30-11
Analog in X30-11 inv
Analog in X30-12
Analog in X30-12 inv
Parameter type: Option
Data type: Uint8
Name
Disabled
Warning
Trip
Jog
Freeze output
Max speed
Switch to open loop
Select setup 1
Parameter Descriptions
Setup: All setups
Change during operation: True
Description
Setup: All setups
Change during operation: True
Description
AU275636650261en-000101 / 130R0334 | 159