Danfoss VLT AutomationDrive FC 301 Programming Manual page 339

VLT AutomationDrive FC 301/302
Programming Guide
Sets up the filter mask for PCD 4. When operating in COS (change-of-state), it is possible to filter out bits in PCD 4 that should not be
sent if they change.
5.11.4 10-3* Parameter Access
Parameter 10-30 Array Index
Table 596: Parameter 10-30 Array Index
10-30 Array Index
Default value: 0
Conversion index: 0
View array parameters. This parameter is only valid when a VLT® DeviceNet MCA 104 is installed.
Parameter 10-31 Store Data Values
Table 597: Parameter 10-31 Store Data Values
10-31 Store Data Values
Default value: [0] Off
Conversion index: –
This parameter is used to activate a function that stores all parameter values in the non-volatile memory, this retaining changed
parameter values at power-down.
Option
[0]*
[1]
[2]
Parameter 10-32 Devicenet Revision
Table 598: Parameter 10-32 Devicenet Revision
10-32 Devicenet Revision
Default value: Size related
Conversion index: 0
The DeviceNet revision number. This parameter is used for EDS file creation.
Parameter 10-33 Store Always
Table 599: Parameter 10-33 Store Always
10-33 Store Always
Default value: [0] Off
Conversion index: –
This parameter is used to select whether parameter data received via the DeviceNet option should always be stored in non-volatile
memory.
Option
[0]*
[1]
Danfoss A/S © 2022.12
Parameter type: Range, 0 - 255
Data type: Uint8
Parameter type: Option
Data type: Uint8
Name
Off
Store all setups
Store all setups
Parameter type: Range, 0 - 65535
Data type: Uint16
Parameter type: Option
Data type: Uint8
Name
Off
On
Setup: 2 setups
Change during operation: True
Setup: All setups
Change during operation: True
Description
Setup: All setups
Change during operation: True
Setup: 1 setup
Change during operation: True
Description
AU275636650261en-000101 / 130R0334 | 339
Parameter Descriptions