Danfoss VLT AutomationDrive FC 301 Programming Manual page 126

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 3-02 Minimum Reference
Table 185: Parameter 3-02 Minimum Reference
3-02 Minimum Reference
Default value: Size related
Conversion index: -3
Enter the minimum reference. The minimum reference is the lowest value obtainable by summing all references. Minimum refer-
ence is active only when parameter 3-00 Reference Range is set to [0] Min.- Max. The minimum reference unit matches:
• The configuration of parameter 1-00 Configuration Mode: For [1] Speed closed loop, RPM; for [2] Torque, Nm.
• The unit selected in parameter 3-01 Reference/ Feedback Unit.
If option [10] Synchronization is selected in parameter 1-00 Configuration Mode, this parameter defines the maximum speed devia-
tion when performing the position offset defined in parameter 3-26 Master Offset. Also see parameter 3-28 Master Offset Speed Ref.
Parameter 3-03 Maximum Reference
Table 186: Parameter 3-03 Maximum Reference
3-03 Maximum Reference
Default value: Size related
Conversion index: -3
Enter the maximum reference. The maximum reference is the highest value obtainable by summing all references. The maximum
reference unit matches:
• The configuration selected in parameter 1-00 Configuration Mode: For [1] Speed closed loop, RPM; for [2] Torque, Nm.
• The unit selected in parameter 3-00 Reference Range.
If [9] Positioning is selected in parameter 1-00 Configuration Mode, this parameter defines the default speed for positioning.
Parameter 3-04 Reference Function
Table 187: Parameter 3-04 Reference Function
3-04 Reference Function
Default value: [0] Sum
Conversion index: –
Option Name
[0]* Sum
[1] External/Preset
Parameter 3-05 On Reference Window
Table 188: Parameter 3-05 On Reference Window
3-05 On Reference Window
Default value: Size related
Conversion index: -3
This parameter is only available with software version 48.XX
126 | Danfoss A/S © 2022.12
Parameter type: Range, -999999.999 - 999999.999 Reference- Feed-
backUnit
Data type: Int32
Parameter type: 0.000 - 999999.999 Reference- FeedbackUnit
Data type: Int32
Parameter type: Option
Data type: Uint8
Description
Sums both external and preset reference sources.
Use either the preset or the external reference source. Shift between external and preset via a com-
mand or a digital input.
Parameter type: Range, 0 - 999999.999 Reference- FeedbackUnit
Data type: Int32
N O T I C E
Parameter Descriptions
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334