Danfoss VLT AutomationDrive FC 301 Programming Manual page 282

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[30] Set vir. mas. pos.
to actual
[31] Activate CAM ta-
ble
[32] Halt
[33] Bit 10 = 0 > CTW
TO always
[78] Reset preventive
maintenance
word
[94] Light load detec-
tion
[95] Evacuation mode
[189] Emergency mode
[190] Emcy mode ref bit
0
[191] Emcy mode ref bit
1
[192] Emcy mode ref bit
2
[195] Test emcy mode
[231] Power limit mot.
[232] Power limit gen.
282 | Danfoss A/S © 2022.12
Description
This option is only available with software version 48.XX.
Bit for setting the virtual master position = the actual follower position. This is needed for setting
the correct starting position for position-controlled virtual master ensuring that the virtual master
ensuring that the virtual master position is aligned with the physical position of the follower.
This option is only available with software version 48.XX.
Signal for activating a new CAM table while running with bumpless transfer.
Use this option to ensure drive runs in the direction which requires least energy (UPS capacity),
during an emergency.
Use this function to operate the drive at reduced DC voltage for evacuating people in case of pow-
er failure.
Enables a choice between 1 of the 8 preset references.
Enables a choice between 1 of the 8 preset references.
Enables a choice between 1 of the 8 preset references.
Emergency mode is activated in a special test mode where the drive stops on all alarms.
This option is only available in FC 302.
See parameter group 4-8* Power Limit. Use this option in the motor mode only.
This option is only available in FC 302.
See parameter group 4-8* Power Limit. Use this option in the generating mode only.
N O T I C E
N O T I C E
N O T I C E
N O T I C E
AU275636650261en-000101 / 130R0334
Parameter Descriptions