Danfoss VLT AutomationDrive FC 301 Programming Manual page 352

VLT AutomationDrive FC 301/302
Programming Guide
• In Ethernet/IP: If no CIP connection is present, None is shown.
• In EtherCAT: If no connection is active, None is shown, otherwise it shows the active PDO.
• In POWERLINK: If no connection is active, None is shown, otherwise it shows the active PDO (23).
Parameter 12-21 Process Data Config Write
Table 621: Parameter 12-21 Process Data Config Write
12-21 Process Data Config Write
Default value: Size related
Conversion index: –
Option Name
[-] None
[109] Mode of operation
[302] Minimum reference
[303] Maximum reference
[312] Catch up/slow down value
[321] Touch target
[322] Master scale numerator
[323] Master scale denominator
[326] Master Offset
[328] Master offset speed ref
[341] Ramp 1 ramp up time
[342] Ramp 1 ramp down time
[351] Ramp 2 ramp up time
[352] Ramp 2 ramp down time
[361] Ramp 3 ramp up time
[362] Ramp 3 ramp down time
[380] Jog/homing ramp time jog ramp time
[381] Quick stop ramp time
[411] Motor speed low limit [RPM]
[412] Motor speed low limit [Hz]
[413] Motor speed high limit [RPM]
[414] Motor speed high limit [Hz]
[416] Torque limit motor mode
[417] Torque limit generator mode
[482] Power limit motor mode
352 | Danfoss A/S © 2022.12
Parameter type: Option, Array [81]
Data type: Uint16
Parameter Descriptions
Setup: All setups
Change during operation: True
Description
AU275636650261en-000101 / 130R0334