Danfoss VLT AutomationDrive FC 301 Programming Manual page 297

VLT AutomationDrive FC 301/302
Programming Guide
Option Name
[2] Commit transaction
[3] Clear error
[4] Write to setup 1
[5] Write to setup 2
[6] Write to setup 3
[7] Write to setup 4
[8] Cancel BTM transaction
Parameter 8-46 BTM Transaction Status
Table 523: Parameter 8-46 BTM Transaction Status
8-46 BTM Transaction Status
Default value: [0] Off
Conversion index: –
Option Name
[0]* Off
[1] Transaction started
[2] Commit transaction
[3] Transaction timeout
[4] Err. non-existing par.
[5] Err. par. out of range
Danfoss A/S © 2022.12
Description
Commit all parameters that have been sent during BTM mode.
When parameter 8-46 BTM Transaction Status shows an error (3–8), the parameter must be
cleared by setting this value.
This option is only available with software version 9.XX.
This option is only available with software version 9.XX.
This option is only available with software version 9.XX.
This option is only available with software version 9.XX.
This option is only available with software version 9.XX.
Abort any BTM activity. Parameters are not committed.
Parameter type: Option
Data type: Uint8
N O T I C E
N O T I C E
N O T I C E
N O T I C E
N O T I C E
Setup: All setups
Change during operation: True
Description
AU275636650261en-000101 / 130R0334 | 297
Parameter Descriptions