Danfoss VLT AutomationDrive FC 301 Programming Manual page 321

VLT AutomationDrive FC 301/302
Programming Guide
Indicates the number of fault events presently stored in parameter 9-45 Fault Code. The buffer capacity is maximum 8 error events.
The buffer and counter are set to 0 by reset or power-up.
Parameter 9-45 Fault Code
Table 553: Parameter 9-45 Fault Code
9-45 Fault Code
Default value: 0
Conversion index: 0
This buffer contains the alarm word for all alarms and warnings that have occurred since the last reset or power-up. The buffer
capacity is maximum 8 error events.
Parameter 9-47 Fault Number
Table 554: Parameter 9-47 Fault Number
9-47 Fault Number
Default value: 0
Conversion index: 0
This buffer contains the alarm word for all alarms and warnings that have occurred since the last reset or power-up. The buffer
capacity is maximum 8 error events.
Parameter 9-52 Fault Situation Counter
Table 555: Parameter 9-52 Fault Situation Counter
9-52 Fault Situation Counter
Default value: 0
Conversion index: 0
Indicates the number of fault events that have occurred since the last reset or power-up.
Table 556: Parameter 9-53 PROFIBUS Warning Word
9-53 PROFIBUS Warning Word
Default value: 0
Conversion index: 0
This parameter shows PROFIBUS communication warnings.
Table 557: PROFIBUS Warning Word
Bit Description
0 Connection with DP-master is not OK.
1 Not used.
2 FDL (fieldbus data link layer) is not OK.
3 Clear data command received.
4 Actual value is not updated.
5 Baud rate search.
6 PROFIBUS ASIC is not transmitting.
7 Initializing of PROFIBUS is not OK.
Danfoss A/S © 2022.12
Parameter type: Range, N/A
Data type: Uint16
Parameter type: Range, N/A
Data type: Uint16
Parameter type: Range, 0 - 1000
Data type: Uint16
Parameter type: Range, 0 - 65535
Data type: V2
Parameter Descriptions
Setup: All setups
Change during operation:
Setup: All setups
Change during operation:
Setup: All setups
Change during operation:
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334 | 321