Danfoss VLT AutomationDrive FC 301 Programming Manual page 55

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 0-42 [Auto On] Key on LCP
Table 30: Parameter 0-42 [Auto On] Key on LCP
0-42 [Auto On] Key on LCP
Default value: [1] Enabled
Conversion index: –
Option Name Description
[0] Disabled Avoids accidental stop of the drive in auto-on mode.
[1]* Enabled
[2] Password Avoids unauthorized start in auto-on mode. If parameter 0-42 [Auto on] Key on LCP is included in the Quick
Menu, then define the password in parameter 0-65 Personal Menu Password.
Parameter 0-43 [Reset] Key on LCP
Table 31: Parameter 0-43 [Reset] Key on LCP
0-43 [Reset] Key on LCP
Default value: [1] Enabled
Conversion index: –
Option Name
[0] Disabled
[1] Enabled
[2] Password
[7] Enabled without OFF
[8] Password without
OFF
Parameter 0-44 [Off/Reset] Key on LCP
Table 32: Parameter 0-44 [Off/Reset] Key on LCP
0-44 [Off/Reset] Key on LCP
Default value: [1] Enabled
Conversion index: –
Enable or disable the [Off/Reset] key.
Option
[0]
[1]*
[2]
Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
Parameter type: Option
Data type: Uint8
Description
No effect when [Reset] is pressed. Avoids accidental alarm reset.
Avoids unauthorized start in auto-on mode. If parameter 0-43 [Reset] Key on LCP is included in
the Quick Menu, then define the password in parameter 0-65 Personal Menu Password.
Resets the drive without setting it in Off mode.
Resets the drive without setting it in Off mode. A password is required when pressing [Reset]
(see option [2] Password).
Parameter type: Option
Data type: Uint8
Name
Disabled
Enabled
Password
Parameter Descriptions
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
Description
AU275636650261en-000101 / 130R0334 | 55