Danfoss VLT AutomationDrive FC 301 Programming Manual page 479

VLT AutomationDrive FC 301/302
Programming Guide
Option Name Description
[0]* Do not reset
[1] Reset counter
To reset the running hours counter to 0, select [1] Reset and press [OK] (see parameter 15-01 Running
Hours). This parameter cannot be selected via the serial port, RS485. Select [0] Do not reset if no reset of
the running-hours counter is required.
5.15.2 15-1* Data Log Settings
The data log enables continuous logging of up to 4 data sources (parameter 15-10 Logging Source) at individual rates (parameter
15-11 Logging Interval). A trigger event (parameter 15-12 Trigger Event) and window (parameter 15-14 Samples Before Trigger) are used
to start and stop the logging conditionally.
Parameter 15-10 Logging Source
Table 769: Parameter 15-10 Logging Source
15-10 Logging Source
Default value: [0] None
Conversion index: -
Select the variables to be logged.
Option Name
[0]* None
[15] Readout: Actual setup
[1397] Alert alarm word
[1398] Alert warning word
[1399] Alert status word
[1472] Legacy alarm word
[1473] Legacy warning word
[1474] Leg. ext. status word
[1600] Control word
[1601] Reference [Unit]
[1602] Reference %
[1603] Status word
[1606] Actual position
[1607] Target position
[1608] Position error
[1610] Power [kW]
[1611] Power [hp]
[1612] Motor voltage
[1613] Frequency
[1614] Motor current
Danfoss A/S © 2022.12
Parameter type: Option, Array [4]
Data type: Uint16
Description
This option is only available with software version 48.XX.
This option is only available with software version 48.XX.
Parameter Descriptions
Setup: 2 setups
Change during operation: True
AU275636650261en-000101 / 130R0334 | 479