Danfoss VLT AutomationDrive FC 301 Programming Manual page 586

VLT AutomationDrive FC 301/302
Programming Guide
Parameter 30-99 Wifi Network Mode
Table 1103: Parameter 30-99 Wifi Network Mode
30-99 Wifi Network Mode
Default value: [1] Access point
Conversion index: -
Option
[0]
[1]*
[2]
5.24 Parameter Group 31-** Bypass Option
This parameter group is only available in FC 302.
Parameter 31-00 Bypass Mode
Table 1104: Parameter 31-00 Bypass Mode
31-00 Bypass Mode
Default value: [0] Drive
Conversion index: -
Select the bypass operating mode.
Option Name
[0]* Drive
[1] Bypass
Parameter 31-01 Bypass Start Time Delay
Table 1105: Parameter 31-01 Bypass Start Time Delay
31-01 Bypass Start Time Delay
Default Value: 30 s
Conversion Index: 0
Setting the time delay to pass from the bypass receives a run command until it starts the motor at full speed. A countdown timer
shows the remaining time.
Parameter 31-02 Bypass Trip Time Delay
Table 1106: Parameter 31-02 Bypass Trip Time Delay
31-02 Bypass Trip Time Delay
Default value: 0 s
Conversion index: 0
586 | Danfoss A/S © 2022.12
Parameter type: Option
Data type: Uint8
Name
None
Access point
Client
N O T I C E
Parameter type: Option
Data type: Uint8
Description
The drive operates the motor.
The motor is operated at full speed during bypass mode.
Parameter Type: Range, 0 - 60 s
Data Type: Uint16
Parameter type: Range, 0 - 300 s
Data type: Uint16
Parameter Descriptions
Setup: 1 setup
Change during operation: True
Description
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
Setup: All setups
Change during operation: True
AU275636650261en-000101 / 130R0334