Danfoss VLT AutomationDrive FC 301 Programming Manual page 287

VLT AutomationDrive FC 301/302
Programming Guide
5.9.3 8-2* Counters
Parameter 8-20: Invalid Memory Write Counter
Table 508: Parameter 8-20: Invalid Memory Write Counter
8-20: Invalid Memory Write Counter
Default value: 0
Conversion index: -
5.9.4 8-3* FC Port Settings
Parameter 8-30 Protocol
Table 509: Parameter 8-30 Protocol
8-30 Protocol
Default value: [0] FC
Conversion index: –
Select the protocol to be used. Changing protocol is not effective until after powering off the drive.
Option
[0]*
[1]
[2]
Parameter 8-31 Address
Table 510: Parameter 8-31 Address
8-31 Address
Default value: 1
Conversion index: 0
Enter the address for the drive (standard) port. Valid range: Depends on the selected protocol.
Parameter 8-32 FC Port Baud Rate
Table 511: Parameter 8-32 FC Port Baud Rate
8-32 FC Port Baud Rate
Default value: Size related
Conversion index: –
Option Name
[0] 2400 Baud
[1] 4800 Baud
[2] 9600 Baud
[3] 19200 Baud
[4] 38400 Baud
Danfoss A/S © 2022.12
Parameter type: Range (0 - 65535)
Data type: Uint8
Parameter type: Option
Data type: Uint8
Name
FC
FC MC
Modbus RTU
Parameter type: Range, 1 - 247
Data type: Uint8
Parameter type: Option
Data type: Uint8
Description
Baud rate selection for the FC (standard) port.
Parameter Descriptions
4-setup: 1 setup
Change during operation: True
Setup: 1 setup
Change during operation: True
Description
Setup: 1 setup
Change during operation: True
Setup: 1 setup
Change during operation: True
AU275636650261en-000101 / 130R0334 | 287