Suzuki Baleno Manual page 1199

1. Stretch it to full length 10 m (33 ft).
2. Power source (12V vehicle battery)
3. Connect one banana plug to positive terminal of power
source (12V vehicle battery) and then the other to negative
terminal to immediately activate.
4. Short harness leads after activation.
5. Drop cloth, blanket or similar them.
WARNING:
Safety precautions must be observed when handling
an activated seat belt pretensioner.
D After activation, the metal surfaces of the seat belt
pretensioner will be very hot. Do not touch the
metal areas of the seat belt pretensioner for about
30 minutes after activation.
D Do not apply water, oil, etc. to activated seat belt
pretensioner.
D If the activated seat belt pretensioner must be
moved before it is cool, wear gloves and handle by
using nonmetal material.
Failure to follow procedures may result in fire or per-
sonal injury.
14) Separate the two banana plugs on the deployment harness.
15) Connect the deployment harness to the power source (12 V
vehicle battery) to immediately activate the pretensioner.
16) Disconnect the deployment harness from the power source
(12 V vehicle battery) and short the two deployment harness
leads together by fully seating one banana plug into the other.
AIR BAG SYSTEM 9J-99