Suzuki Baleno Manual page 1181

ALWAYS CARRY AIR BAG (INFLATOR) MODULE
WITH TRIM COVER (AIR BAG OPENING) AWAY
FROM BODY.
ALWAYS PLACE AIR BAG (INFLATOR) MODULE
ON WORKBENCH WITH TRIM COVER (AIR BAG
OPENING) UP, AWAY FROM LOOSE OBJECTS.
1. Slit on workbench
2. Workbench vise 3. Lower mounting bracket
1) Turn ignition switch to "LOCK", remove key and put on safety
glasses.
2) Check that there is no open, short or damage in special tool (De-
ployment harness). If any faulty is found, do not use it and be
sure to use new deployment harness.
Special Tool (Deployment harness)
(A): 09932-75030
3) Short the two deployment harness leads together by fully seat-
ing one banana plug into the other.
WARNING:
Deployment harness shall remain shorted and not be
connected to a power source until the air bag is to be
deployed.
Special Tool (Deployment harness)
1. Shorted
(A): 09932-75030
4) Remove driver or passenger air bag (inflator) module from ve-
hicle referring to Section 3C1 or 9J.
5) With driver air bag (inflator) module, remove horn lead, horn
buttons and clamp from driver air bag (inflator) module.
WARNING:
D Always carry a live air bag (inflator) module with
trim cover away from you.
D When storing a live air bag (inflator) module or
when leaving a live air bag (inflator) module unat-
tended on a bench or other surface, always face the
bag and trim cover up and away from the surface.
As the live passenger air bag (inflator) module must
be placed with its bag (trim cover) facing up, place
it on the workbench with a slit or use the workbench
vise to hold it securely at its lower mounting brack-
et.
D This is necessary so that a free space is provided
to allow the air bag to expand in the unlikely event
of accidental deployment.
Failure to follow procedures may result in personal in-
jury.
6) Temporarily place driver or passenger air bag (inflator) module
on the workbench or the vise according to above "WARNING".
AIR BAG SYSTEM 9J-81