Suzuki Baleno Manual page 1186

9J-86 AIR BAG SYSTEM
DEPLOYMENT INSIDE VEHICLE
Use this procedure when scrapping the entire vehicle including the driver and/or passenger air bag (inflator) mod-
ule(s).
CAUTION:
When vehicle itself will be used again, deploy the air bag module outside vehicle according to "DE-
PLOYMENT OUTSIDE VEHICLE" in this section, for deploying it inside will cause the instrument pan-
el, glove box and their vicinity to be deformed.
Failure to observe this CAUTION could cause unneeded vehicle inspection and repair.
WARNING:
The following precautions must be observed for this work. Failure to observe any of them may result
in personal injury.
D To avoid an accidental deployment, this work should be performed by no more than one person.
D The procedure should be followed strictly as described here.
D Be sure to read "HANDLING PRECAUTIONS" for the air bag (inflator) module beforehand.
D Never connect deployment harness to any power source before connecting deployment harness
to the air bag (inflator) module. Deployment harness shall remain shorted and not be connected
to a power source until the air bag is to be deployed.
D The air bag (inflator) module will immediately deploy the air bag when a power source is connected
to it. Wear safety glasses throughout this entire deployment and disposal procedure.
D Wear suitable ear protection when deploying air bag. Also, advise those who are in the area close
to deployment site to wear suitable ear protection.
D Do not deploy driver and passenger air bag (inflator) modules at the same time.
1) Turn ignition switch to "LOCK", remove key and put on safety
glasses.
2) Remove all loose objects from front seats and instrument panel.
3) Driver side:
Remove steering wheel side cap (left side) and disconnect air
bag (inflator) module connector.
Passenger side:
Remove glove box from instrument panel and disconnect air
bag (inflator) module connector.
4) Confirm that each air bag (inflator) module is securely mounted.