Table of Contents
Advertisement
09-14
▶
Pedal Height
Push rod
-
Check the pedal height with below
procedures:
1.
Start the engine and measure the length
Stop lamp
(A) between floor mat and pedal.
switch
2.
If the measured value is out of the
specified value, adjust the length.
Specified value (B)
-
Adjust the pedal height with below
procedures:
1.
Disconnect the stop lamp switch connector.
Unscrew the lock nut and remove the stop
2.
lamp switch assembly.
Loosen the lock nut on the pedal push rod.
3.
Turn the pedal push rod to adjust the pedal
4.
height.
Tighten the lock nut.
5.
Install the stop lamp switch assembly.
6.
Connect the stop lamp switch connector.
7.
Check if the stop lamps come on when
8.
pressing the brake pedal around 5 mm.
If the stop lamp dpes not come on, adjust
9.
the stop lamp switch assembly again.
If the stop lamps come on, tighten the lock
10.
nut and measure the pedal height again.
155mm
Advertisement
Table of Contents
Troubleshooting
