Table of Contents
Advertisement
02-8
3. AIR BAG MODULE AND RELATED COMPONENTS
This section describes the air bag module installed in ACTYON. The module consists of the inflator, the
cushion, and the mounting cover.
1) DAB (Driver Air Bag)
The driver's air bag is installed inside the steering wheel. If the acceleration sensor (inside the air bag
unit) is activated by the deceleration from vehicle collision, the detonation is fired by the electrical signal
of the air bag unit.
Then, the detonation sets off explosives and nitrogen gas is generated.
At this point, the air bag very quickly deploys and the gas is emitted from the relieving hole to absorb
impact upon the driver.
(1) Components
Front View
1.
Air bag cover
2.
Air bag housing
3.
Air bag cushion (approx. 50 liters)
4.
Inflator* (approx. 190 Kpa)
5.
Retainer ring
6.
Horn switch
Inflator*
The inflator is composed of the detonator,
explosives, and the gas generator. It inflates
air bag when vehicle collides.
Rear View
Advertisement
Table of Contents
Troubleshooting
