Flexio Control Register (Flexio_Ctrl) - NXP Semiconductors MKL27Z128VFM4 Reference Manual

Memory Map and Registers

39.3.3 FlexIO Control Register (FLEXIO_CTRL)

.
Address: 4005_F000h base + 8h offset = 4005_F008h
Bit 31 30 29
R
W
Reset 0 0 0
Bit 15 14 13
R
W
Reset 0 0 0
Field
31 Doze Enable
DOZEN
Disables FlexIO operation in Doze modes. This field is ignored and the FlexIO always disabled in low-
leakage stop modes.
0 FlexIO enabled in Doze modes.
1 FlexIO disabled in Doze modes.
30 Debug Enable
DBGE
Enables FlexIO operation in Debug mode.
0 FlexIO is disabled in debug modes.
1 FlexIO is enabled in debug modes
29–3 This field is reserved.
Reserved This read-only field is reserved and always has the value 0.
2 Fast Access
FASTACC
Enables fast register accesses to FlexIO registers, but requires the FlexIO clock to be at least twice the
frequency of the bus clock.
0 Configures for normal register accesses to FlexIO
1 Configures for fast register accesses to FlexIO
1 Software Reset
SWRST
The FlexIO Control Register is not affected by the software reset, all other logic in the FlexIO is affected by
the software reset and register accesses are ignored until this bit is cleared. This register bit will remain
set until cleared by software, and the reset has cleared in the FlexIO clock domain.
752
28 27 26 25
0 0 0 0
12 11 10 9
0
0 0 0 0
FLEXIO_CTRL field descriptions
Table continues on the next page...
KL27 Sub-Family Reference Manual , Rev. 5, 01/2016
24 23 22 21
0
0 0 0 0
8 7 6 5
0 0 0 0
Description
20 19 18 17
0 0 0 0
4 3 2 1
0 0 0 0
Freescale Semiconductor, Inc.
16
0
0
0