Table of Contents
Advertisement
Chapter 7
Power Management
7.1 Introduction
Information about the various chip power modes and functionality of the individual
modules in these modes can be found here.
See
AN4503: Power Management for Kinetis and ColdFire+ MCUs
for further details on
power management techniques.
7.2 Clocking modes
Information found here describes the various clocking modes supported on this device.
7.2.1 Partial Stop
Partial Stop is a clocking option that can be taken instead of entering Stop mode and is
configured in the SMC Stop Control Register (SMC_STOPCTRL). The Stop mode is
only partially entered, which leaves some additional functionality alive at the expense of
higher power consumption. Partial Stop can be entered from either Run mode or VLP
Run mode.
When configured for PSTOP2, only the core and system clocks are gated and the bus
clock remains active. The bus masters and bus slaves clocked by the system clock enter
Stop mode, but the bus slaves clocked by bus clock remain in Run (or VLP Run) mode.
The clock generators in the MCG and the on-chip regulator in the PMC also remain in
Run (or VLP Run) mode. Exit from PSTOP2 can be initiated by a reset, an asynchronous
interrupt from a bus master or bus slave clocked by the system clock, or a synchronous
interrupt from a bus slave clocked by the bus clock. If configured, a DMA request (using
the asynchronous DMA wakeup) can also be used to exit Partial Stop for the duration of a
DMA transfer before the device is transitioned back into PSTOP2.
KL27 Sub-Family Reference Manual , Rev. 5, 01/2016
Freescale Semiconductor, Inc.
89
Advertisement
Table of Contents
