Address Register (Usbx_Addr); Bdt Page Register 1 (Usbx_Bdtpage1) - NXP Semiconductors MKL27Z128VFM4 Reference Manual

33.5.11 Address register (USBx_ADDR)

Holds the unique USB address that the USB module decodes when in Peripheral mode
(HOSTMODEEN=0). CTL[USBENSOFEN] must be 1. The Address register is reset to
0x00 after the reset input becomes active or the USB module decodes a USB reset signal.
This action initializes the Address register to decode address 0x00 as required by the
USB specification.
Address: 4007_2000h base + 98h offset = 4007_2098h
Bit 7
Read 0
Write
Reset 0
Field
7 This field is reserved.
Reserved This read-only field is reserved and always has the value 0.
ADDR USB Address
Defines the USB address that the USB module decodes in peripheral mode.

33.5.12 BDT Page register 1 (USBx_BDTPAGE1)

Provides address bits 15 through 9 of the base address where the current Buffer
Descriptor Table (BDT) resides in system memory. See
bit BDT Base Address is always aligned on 512-byte boundaries, so bits 8 through 0 of
the base address are always zero.
Address: 4007_2000h base + 9Ch offset = 4007_209Ch
Bit 7
Read
Write
Reset
0
Freescale Semiconductor, Inc.
6 5
0 0
USBx_ADDR field descriptions
6 5
BDTBA
0 0
KL27 Sub-Family Reference Manual , Rev. 5, 01/2016
Chapter 33 Universal Serial Bus (USB) FS Subsystem
4 3
ADDR
0 0
Description
Buffer Descriptor
4 3
0 0
2 1
0 0
Table. The 32-
2 1
0 0
0
0
0
0
0
551