Usb Power Management; Introduction; References - NXP Semiconductors MKL27Z128VFM4 Reference Manual

Introduction

TYPE A
VBUS
D+
D-

33.1.4 USB power management

The regulator should be put into STANDBY mode whenever the chip is in Stop mode.
33.2 Introduction
This chapter describes the USB full speed controller. The USBFS controller provides
functionality for implementing a USB2.0 full-speed compliant peripheral and interfaces
to a USBFS transceiver.
This chapter describes the following registers that have similar
names: USB_CTL, USB_CTRL, and USB_CONTROL. These
are all separate registers.

33.2.1 References

The following publications are referenced in this document. For copies or updates to
these specifications, see the USB Implementers Forum, Inc. website at http://
www.usb.org.
• Universal Serial Bus Specification, Revision 2.0 , 2000, with amendments including
those listed below
530
VDD
VOUT33
Cstab
VREGIN
USB0_DP
USB0_DM
Figure 33-4. USB regulator bus supply
KL27 Sub-Family Reference Manual , Rev. 5, 01/2016
To PMC and Pads
USB
Regulator
XCVR
USB
NOTE
Chip
USB
Controller
Freescale Semiconductor, Inc.