Human-Machine Interfaces; Module To Module Interconnects; Interconnection Overview - NXP Semiconductors MKL27Z128VFM4 Reference Manual

2.2.9 Human-machine interfaces

The following human-machine interfaces (HMI) are available on this device:
Module
General purpose input/output (GPIO)

2.3 Module to module interconnects

2.3.1 Interconnection overview

The following table lists the module to module interconnections for this device.
Peripheral Signal
TPM1 CH0F, CH1F
LPTMR Hardware
trigger
TPMx TOF
PIT CHx TIF0, TIF1
RTC ALARM or
SECONDS
Freescale Semiconductor, Inc.
Table 2-10. HMI modules
Some general purpose input or output (GPIO) pins are capable of interrupt and
DMA request generation.
Table 2-11. Module-to-module interconnects
— to Use Case
Peripheral
to ADC ADC
(Trigger) Triggering (A
AND B)
to ADC ADC
(Trigger) Triggering (A
or B)
to ADC ADC
(Trigger) Triggering (A
or B)
to ADC ADC
(Trigger) Triggering (A
or B)
to ADC ADC
(Trigger) Triggering (A
or B)
Table continues on the next page...
KL27 Sub-Family Reference Manual , Rev. 5, 01/2016
Description
Control
SIM_SOPT7[ADC0ALTTRGEN] = 0 Ch0 is A, and Ch1 is
SIM_SOPT7[ADC0TRGSEL] and
SIM_SOPT7[ADC0PRETRGSEL]
to select A or B
SIM_SOPT7[ADC0TRGSEL],
SIM_SOPT7[ADC0PRETRGSEL]
to select A or B
SIM_SOPT7[ADC0TRGSEL],
SIM_SOPT7[ADC0PRETRGSEL]
to select A or B
SIM_SOPT7[ADC0TRGSEL],
SIM_SOPT7[ADC0PRETRGSEL]
to select A or B
Chapter 2 Introduction
Comment
B, selecting this
ADC trigger is for
supporting A and B
triggering. In Stop
and VLPS modes,
the second trigger
must be set to >10
µs after the first
trigger
—
—
—
—
45