Upgrading a TN802B IP Interface Assembly to
TN2302AP IP Media
Processor
Return to Task List
To upgrade IP Interface Assembly to IP Media Processor, you must replace
•
the TN802B circuit pack with a TN2302AP circuit pack
•
the TN799 circuit pack with a TN799DP circuit pack, if necessary
•
the H600 512, G1 external cable assembly with an IP Media Processor adapter
Task List: Upgrade TN802B to TN2302AP
1
Perform Pre-upgrade Administration
2
Remove the Circuit Packs
3
Replace the Cables
4
Install the Circuit Packs
5
Perform Additional Administration Steps
Perform Pre-upgrade Administration
Return to Task List
1
Type
change ip-interfaces
2
Set the Enable Eth Pt field to n.
3
Press Enter to effect the change.
4
Type
change ip-interfaces
5
Delete the information in the Type , Slot , and Node Name fields for each TN802B you are
replacing.
6
Press Enter to save the information and effect the new settings.
SI Installation and Upgrades
June 2004
Upgrading a TN802B IP Interface Assembly to TN2302AP IP Media Processor
on page 613
on page 614
on page 615
on page 615
on page 615
and press Enter. See
and press Enter.
Figure 237, IP Interfaces screen,
Add IP Solutions
on page 609.
613