Upgrading A Tn802B Ip Interface Assembly To Tn2302Ap Ip Media Processor - Avaya CMC1 Installation Manual

Adding or Removing Hardware
Add IP Solutions
Install the circuit packs
1
If replacing the TN799 circuit pack, install the TN799B/C circuit pack in the slot vacated by the
TN799 circuit pack.
2
For convenience install the TN2302AP circuit pack in the rightmost slot vacated by the TN802
and where the adapter is connected to the corresponding backplane connector. The other 2 slots
are now available for other circuit packs.
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The RED LED stays
on until an IP address is assigned to the circuit pack.
3
Type list configuration all and press Enter to verify that the system recognizes the TN2302AP
circuit pack.
Administration
1
Administer the TN799B/C C-LAN. Refer to the Administration for Network Connectivity for
Avaya Communication Manager.
2
Administer the IP Media Processor, which is usually done remotely. Call your service
representative to start the process.
3
Complete the administration and testing. Refer to
Media Processor
Upgrading a TN802B IP Interface Assembly to
TN2302AP IP Media Processor
To upgrade an IP Interface Assembly to IP Media Processor, you must replace
•
The TN802B circuit pack with a TN2302AP circuit pack
•
The TN799 circuit pack with a TN799B/C circuit pack, if necessary
•
The H600-512, G1 external cable assembly with an IP Media Processor adapter.
244
on page 240 and Test the External Connection to the LAN
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Initial Administration Steps for C-LAN and IP
on page 242.
June 2004