Chapter 3: Configuration Overview; Configuration Overview; About Defining The Services Interface - Avaya G430 Manual

Chapter 3: Configuration overview

Configuration overview

A new Branch Gateway comes with default configuration settings. There are certain items that
you must configure, according to your system specifications, before using the Branch Gateway.
Configuration of other items depends on the specifications of your network.
A new Branch Gateway has two physical interfaces for management. These are the Services
interface and the USB-modem interface.
You must also ensure that the Branch Gateway is properly configured for whichever methods
you intend to use for accessing the Branch Gateway. For information on accessing the Branch
Gateway, see
Related topics:

About defining the Services interface

Defining the USB-modem interface
Other interfaces
Configuration using CLI
Configuration using GUI applications
Configuration changes and backups
Firmware version control
About defining the Services interface
No configuration of the Services interface is necessary. The Services interface has the fixed
IP address 192.11.13.6. However, the console device you connect to the Services port requires
a specific configuration of its network settings, as explained in
the Services port
Administering Avaya G430 Branch Gateway
Accessing the Branch Gateway
on page 22
on page 23
on page 25
on page 30.
on page 27.
on page 21
on page 22
on page 23
on page 24
Accessing the gateway through
October 2013 21