Add Ttc Japanese 2-Mbit Trunks; Add Dcs Interface - Avaya CMC1 Installation, Upgrades And Additions

Adding or Removing Hardware
Save Translations
1. Type save translation and press
translation information in memory and write it to the translation cards.
2. Update backup translation cards, if required.

Add TTC Japanese 2-Mbit Trunks

The TN2242 Japan 2-Mbit trunk interconnects to other vendor equipment in
Japan as well as to other switches through the Time Division Multiplexor (TDM).
Installing the trunk
1. Determine the port assignment of the trunk from the Trunk Group form.
EXAMPLE:
2. Install a TN2242 circuit pack in assigned carrier slot.
3. Connect the H600-513 cable from the cabinet to the Time Division
Multiplexor device.
4. To administer forms, see the following sections in the Administrator's Guide
for Avaya MultiVantage Software.

Add DCS Interface

Systems in a Distributed Communications System (DCS) network are
interconnected by both tie trunks (for voice communications) and data links (for
control and transparent feature information). These data links, also called DCS
signaling links, support the feature transparency.
DCS requires a special signaling connection to carry the information needed to
make the DCS features work. This signaling connection, or link, between two
switches in a DCS network is implemented either:
over an ISDN-PRI D-channel.
over a TCP/IP connection.
5-46
Issue 5 October 2002
3
Cabinet (Port
Network)
For ISDN applications, see ISDN Service.
For non-ISDN applications, see Managing Trunks.
. This instructs the system to take all
Enter
A 07
Carrier Slot
Number
01
Port
Number
555-233-118