Configuring The Voip Resources - Avaya G700 Installation And Upgrades

Type configure at the MG-???-n(super)# prompt.
9.
Type show interface mgp to verify that the G700 Media Gateway has the correct IP
10.
address.
End
Assign the Default IP Route to the G700 Media Gateway
Begin
At the MG-???-n(configure)# prompt
Type set ip route <destination> <mask> <gateway>. The destination and mask
1.
are 0.0.0.0 for the default gateway.
Type show ip route mgp to view the results.
2.
3. Repeat step 1 for additional ip routes, if needed. Usually, only a default route is needed. Refer to
your planning document.
End
To complete the configuration of the G700 Media Gateway, you will establish a list of controllers. This list
begins with the IP address of the primary controller. In the event that the G700 Media Gateway loses contact
with its primary controller, it will seek to register with the other controllers on this list. These controllers are
the S8300 Media Server local survivable backups.
Up to ten IP addresses separated by commas can be entered to form the controller list.

Configuring the VoIP Resources

From the G700 Media Gateway command line interface you will assign IP addresses to the VoIP resource
resident on the G700 Media Gateway and to any installed MM760 VoIP Media Modules.
Assign IP Addresses to the VoIP Resources
Begin
At the MG-mmm-n(config)# prompt
Type set interface voip <number> <ip address>
1.
For example:
set interface voip v0 132.236.73.3
v0 designates the VoIP resource resident on the G700 Media Gateway. The MM760 VoIP Media
Modules are designated according the slot (for example, v1, v2, v3, v4) in which the Media
Module has been installed.
Type show voip-parameters to display the table of VoIP resources.
2.
Installation and Upgrades for G700
555-234-100 – Issue 1 – May 2002
2 G700 Media Gateway: Initial Network Set-Up
39