Advertise Med Guest-Voice-Signaling - Dell Z9500 Reference Manual

Version
7.6.1.0
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
show running-config lldp

advertise med guest-voice-signaling

To advertise a separate limited voice service for a guest user when the guest voice control packets use a
separate network policy than the voice data, configure the system.
Z9500
Syntax
advertise med guest-voice-signaling {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med guest-voice-signaling
{vlan-id layer2_priority DSCP_value} | {priority-tagged number}
command.
Parameters
vlan-id
layer2_priority
DSCP_value
priority-tagged
number
Defaults unconfigured.
Command CONFIGURATION (conf-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Link Layer Discovery Protocol (LLDP)
Description
Introduced on the C-Series and E-Series.
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
— displays the LLDP running configuration.
Enter the VLAN ID. The range is from 1 to 4094.
Enter the Layer 2 priority. The range is from 0 to 7.
Enter the DSCP value. The range is from 0 to 63.
Enter the keywords priority-tagged then the Layer 2
priority. The range is from 0 to 7.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
1157