Lacp System-Priority; Port-Channel-Protocol Lacp - Dell S4810 Reference Manual

lacp system-priority

Configure the LACP system priority.
S4810
Syntax
lacp system-priority priority-value
Parameters
priority-value
Defaults 32768
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.2.1.1

port-channel-protocol lacp

Enable LACP on any LAN port.
S4810
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp
command.
Command INTERFACE
Modes
Link Aggregation Control Protocol (LACP)
Enter the port-priority value. The higher the value number,
the lower the priority. The range is from 1 to 65535. The
default is 32768.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1025