Maximum-Paths - Dell S4810 Reference Manual

Parameters
seconds
Defaults 1200 seconds
Command ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Usage
Change the maximum LSP lifetime with this command. The maximum LSP lifetime
Information
must always be greater than the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of
time. If the value is higher, the overhead is reduced on slower-speed links.
Related lsp-refresh-interval
Commands

maximum-paths

Allows you to configure the maximum number of equal cost paths allowed in a routing table.
S4810
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number
996
The maximum lifetime of LSP in seconds. This value must be
greater than the lsp-refresh-interval command. The
higher the value the longer the LSPs are kept. The range is
from 1 to 65535. The default is 1200.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
— sets the link-state packet (LSP) refresh interval.
Enter a number as the maximum number of parallel paths an
IP routing installs in a routing table. The range is from 1 to 16.
The default is 4.
Intermediate System to Intermediate System (IS-IS)