Max-Area-Addresses; Max-Lsp-Lifetime - Dell Force10 S4810P Reference Manual

Version 7.5.1.0
Usage
The refresh interval determines the rate at which route topology information is transmitted
Information
preventing the information from becoming obsolete.
The refresh interval must be less than the LSP lifetime specified with the max-lsp-
lifetime command. A low value reduces the amount of time that undetected link state
database corruption can persist at the cost of increased link utilization. A higher value reduces
the link utilization caused by the flooding of refreshed packets.
Related

max-lsp-lifetime

Commands

max-area-addresses

Configure manual area addresses.
E-Series, S4810
Syntax max-area-addresses number
To return to the default values, use the no max-area-addresses command.
Parameters
number
Defaults 3 addresses
Command Modes ROUTER ISIS
Command History
Version 8.3.12.0
Version 7.5.1.0
Usage Use this command to configure the number of area addresses on router. This value must be
Information consistent with routers in the same area, otherwise the router forms only Level 2 adjacencies.
The value must be same among all the routers to form Level 1 adjacencies.
max-lsp-lifetime
Set the maximum time that link-state packets (LSPs) exist without being refreshed.
E-Series, S4810
Syntax max-lsp-lifetime seconds
Added support for LSP Throttling Enhancement.
– sets the maximum interval that LSPs persist without being refreshed.
Set the maximum number of manual area addresses. The range is 3 to
6. The default is 3.
Introduced on the S4810.
Added support for LSP Throttling Enhancement.
997