Max-Area-Addresses; Max-Lsp-Lifetime - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

max-area-addresses

Configure manual area addresses.

max-area-addresses number

To return to the default values, use the no max-area-addresses command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 7.5.1.0

To configure the number of area addresses on router, use this command. This

value must be consistent with routers in the same area, otherwise the router forms

only Level 2 adjacencies. The value must be same among all the routers to form

Level 1 adjacencies.

Set the maximum time that link-state packets (LSPs) exist without being refreshed.

max-lsp-lifetime seconds

To restore the default time, use the no max-lsp-lifetime command.

Intermediate System to Intermediate System (IS-IS)

Set the maximum number of manual area addresses. The

range is from 3 to 6. The default is 3.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Added support for LSP Throttling Enhancement.