Max-Area-Addresses - Dell C9000 Series Reference Manual

Version
7.5.1.0
Usage Information The refresh interval determines the rate at which route topology information is
transmitted preventing the information from becoming obsolete.
The refresh interval must be less than the LSP lifetime specified with the max-lsp-
lifetime command. A low value reduces the amount of time that undetected link
state database corruption can persist at the cost of increased link utilization. A higher
value reduces the link utilization the flooding of refreshed packets causes.
Related max-lsp-lifetime
Commands refreshed.

max-area-addresses

Configure manual area addresses.
C9000 Series
Syntax
max-area-addresses number
To return to the default values, use the no max-area-addresses command.
Parameters
number
Defaults 3 addresses
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
Description
Added support for LSP Throttling Enhancement.
— sets the maximum interval that LSPs persist without being
Set the maximum number of manual area addresses. The range
is from 3 to 6. The default is 3.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Intermediate System to Intermediate System (IS-IS) 1091