Igmp And Igmp Snooping Commands; Introduction - Allied Telesis AT-x230-10GP User Manual

23

Introduction

Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection and IGMP Snooping.
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
C613-50104-01 REV A
IGMP and IGMP
"clear ip igmp" on page 742
"clear ip igmp group" on page 743
"clear ip igmp interface" on page 744
"debug igmp" on page 745
"ip igmp" on page 746
"ip igmp access-group" on page 747
"ip igmp flood specific-query" on page 748
"ip igmp immediate-leave" on page 749
"ip igmp last-member-query-count" on page 750
"ip igmp last-member-query-interval" on page 751
"ip igmp limit" on page 752
"ip igmp maximum-groups" on page 753
"ip igmp querier-timeout" on page 755
"ip igmp query-holdtime" on page 756
"ip igmp query-interval" on page 758
"ip igmp query-max-response-time" on page 760
Command Reference for x230 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Snooping
Commands
740