Igmp And Igmp Snooping Commands; Introduction - Allied Telesis AT-x510-28GTX Command Reference Manual

29

Introduction

Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection, IGMP Snooping and IGMP Proxy.
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
C613-50102-01 REV C
IGMP and IGMP
"clear ip igmp" on page 1114
"clear ip igmp group" on page 1115
"clear ip igmp interface" on page 1116
"debug igmp" on page 1117
"ip igmp" on page 1118
"ip igmp access-group" on page 1119
"ip igmp flood specific-query" on page 1120
"ip igmp immediate-leave" on page 1121
"ip igmp last-member-query-count" on page 1122
"ip igmp last-member-query-interval" on page 1123
"ip igmp limit" on page 1124
"ip igmp maximum-groups" on page 1125
"ip igmp mroute-proxy" on page 1127
"ip igmp proxy-service" on page 1128
"ip igmp querier-timeout" on page 1129
"ip igmp query-holdtime" on page 1130
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Snooping
Commands
1112