Igmp And Igmp Snooping Commands; Introduction - Allied Telesis IE220 Series Manual

26

Introduction

Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection, IGMP Snooping and IGMP Proxy.
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
C613-50644-01 Rev B
IGMP and IGMP
"clear ip igmp" on page 965
"clear ip igmp group" on page 966
"clear ip igmp interface" on page 967
"debug igmp" on page 968
"ip igmp" on page 969
"ip igmp access-group" on page 970
"ip igmp flood-group" on page 971
"ip igmp flood specific-query" on page 973
"ip igmp immediate-leave" on page 974
"ip igmp last-member-query-count" on page 975
"ip igmp last-member-query-interval" on page 976
"ip igmp limit" on page 977
"ip igmp maximum-groups" on page 978
"ip igmp mroute-proxy" on page 980
"ip igmp proxy-service" on page 981
"ip igmp querier-timeout" on page 983
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Snooping
Commands
963